2" Brake Floater, 9-1/4" Rotor, 2-Piston Caliper with M2 Bearing

Double Wide Brake Floater for 2-Piston Caliper, 2” Splined Rear Axle and 9-1/4" Brake Rotor with M2 Bearing

This version of our Double Wide Brake Floater for 2-Piston Caliper, 2” Splined Rear Axle and 9-1/4" Brake Rotor swaps out the standard bearing for the M2 Bearing. The M2 process introduces a treatment to metal surfaces to reduce friction and drag, enhance oiling capabilities, and prolong life. M2 bearings begin as the highest quality Superior bearings. After adding the M2 treatment, all sealed bearings are repacked with DAYLube™ High Performance Grease. The M2 bearing for the 2” axle also uses a reduced contact seal to reduce drag even more. 

Caliper spacing is 3-1/4" for the Wilwood Dynalite Single 2-Piston Brake Caliper. Fits the Hyper 600cc Jacob's Ladder Chassis. Uses the 9-1/4" brake rotor. Bearing and snap ring are included. These bearings are pre-packed and ready to go, but for maintenance and re-packing, DAYLube™ High Performance Grease is your go-to product, so be sure to have it on hand. Very little amount of grease is needed for these bearings. DAYLube™ High Performance Grease is highly recommended for this product as it does not fling off and is compatible with the treatment. 

Use 20.5" steel brake rod on '07 & Up Hyper Chassis in the standard wheelbase configuration. Use 19.5" steel brake rod on '07 & Up Hyper Chassis in the short wheelbase configuration. 

Additional hardware not included in kit: 

(1) 7/16-20 x 1-1/2" HHCS to attach the steel brake rod

(2) 3/8-24 x 1-1/2" HHCS with (2) 3/8-20 Nylock half nuts to attach the brake caliper